/ Register

Viking Audio

Discussion in 'General Car Audio Discussions' started by electrolytic, Apr 18, 2007.

Page 30 of 64
  1. cccullen

    cccullen Full Member

    ya electro, try to open it up. maybe the damage isn't so bad. I know how you must feel right now but you never know, that damage may not be bad at all.

    I remember my first set up, i didn't know much at all and i taped the wires (power, ground, remote and RCA's) all together. I was using a RF punch 150 powering 2 12" Cerwin Vega's in my Jeep. After a month, the whole thing fried, head unit and all. didn't help much that my jeep got wet a lot inside. Two months after that, my subs got stolen.I was also strapped for cash at the time.lol

    Only after it happened i found you're not supposed to put all the wires together. I didn't have a sound system for 2 years after that happened and not until about 2 years ago did i really decide to try again.
     
    Last edited: Mar 25, 2008
    cccullen, Mar 25, 2008
    #581
  2. electrolytic

    electrolytic Full Member

    Ya, the bottom is off, looks clean, i can't see any burns. Swapped amps and my system came back, then brought it in my house and hooked it up to my surround sound and still nothing. It powers on, fan is on but nothing comes out. I don't want this stupid thing anymore lol what a waste. Going for a hifonics then that's it!!! I'll give up after i fry that one lol.
     
    electrolytic, Mar 25, 2008
    #582
  3. cccullen

    cccullen Full Member

    I would try to have it fixed electro. Even if you don't want it anymore, spend a little money to have it fixed then sell the damn thing if you don't want it anymore. Once you sell it, it would have paid for your Hifonics amp.
     
    cccullen, Mar 25, 2008
    #583
  4. electrolytic

    electrolytic Full Member

    I'm gonna torch it with lighter fluid then drag it behind my car with a chain, then throw it in the ocean. Then i'll be happy lol.
     
    electrolytic, Mar 25, 2008
    #584
  5. cccullen

    cccullen Full Member

    lol. if you're gonna do that then throw it over my way. I'll have that beast fixed.

    you can even put it up on ebay not functioning, you should still be able to get pretty good money for it.
     
    cccullen, Mar 25, 2008
    #585
  6. pedro quiroga

    pedro quiroga Well-Known Member

    oh yeah people are dying to get there hands on one working or not.

    and if you dont want to mess with shipping try craigslist. do you have that in canada?

    my bud got rid of a bunch of stuff in 2 days using that.now he has more room for more junk.lol
     
    pedro quiroga, Mar 25, 2008
    #586
  7. electrolytic

    electrolytic Full Member

    Never tried craiglist i think it's here too. I have an ebay account so i can sell it there. Going to see if i can get it fixed locally, if not then i'll just sell it for parts. Should get at least $200.00. I paid over $700.00 for it. Man that stings a bit lol. What's a good amp for about $400-$500.00 Hifonics? I want three way protection, overload, overheat, short circuit and all that crap. I can't be trusted lol.
     
    electrolytic, Mar 25, 2008
    #587
  8. pedro quiroga

    pedro quiroga Well-Known Member

    [​IMG]

    350 bucks.thats a deal.
     
    pedro quiroga, Mar 25, 2008
    #588
  9. electrolytic

    electrolytic Full Member

    Was looking at this one, matches my subs rating exactly.

    Hifonics BXi2008D Amp: Mono

    Hifonics BXi2008D
    2000-Watt Super D-Class Amplifier 1-Channel Mono-Block
    RMS Power @ 4 ohms: 650 watts x 1
    RMS Power @ 2 ohms: 1300 watts x 1
    RMS Power @ 1 ohm: 2000 watts x 1
    1-Channel Mono-Block Operation
    Super D-Class Amplifier Topography
    Ultra-Fi MOSFET Outputs
    Illuminated Hifonics Logo
    PWM MOSFET EXVP (Exponential Vari-Power Supply)
    SPC-Twin Turbo-Torroids with Simpatico Coil Design
    Fully Adjustable Accu Cross Crossovers include:
    - 24 dB Subsonic Filter (Adjusts 15 Hz to 35 Hz)
    Phase Shift Adjustments, (0 to +180-Degrees)
    24 dB Low-Pass Crossover (Adjusts 35 Hz to 250 Hz)
    Bass Boost: Variable Bass Equalization (+ 10dB @ 45 Hz)
    Remote Bass Control Included
    Balanced Line INputs w Optional Hifonics MM-BLD1
    Gold RCA Line Outputs:
    Permit Amplifier Daisy-Chaining
    (0.2v to 9-volts Signal Level)
    4-Guage Power Connectors
     

    Attached Files:

    electrolytic, Mar 25, 2008
    #589
  10. electrolytic

    electrolytic Full Member

    I don't want ED they are lame LOL but don't tell azn i said that! That is a nice amp though, but i want 2000 watts rms just for bass at 1 0hm
     
    electrolytic, Mar 25, 2008
    #590
  11. electrolytic

    electrolytic Full Member

    Is 2400 watts too much for my sub? probably eh.

    Hifonics Bxi 2407D
    2400W Super D-Class 1-Channel Amplifer
    Hifonics Bxi 2407D Amp: Mono

    2400W RMS Mono Block Class D 1 Ohm Stable Amp
    RMS Power @ 2-Ohm: 1500W x 1
    RMS Power @ 1-Ohm: 2400W x 1
    Super D-Class Amplifer topography
    Highly Efficient Super D-Class Amplifier Circuitry With Oversized MOSFET Output
    Hifonics New Illuminated Heat-Sink Design With Blue LED Light Pumps
    Hifonics Blue Illuminated Logo
    Twin-Turbo Torroid Coil Design
    Fully Adjustable Accu-Cross™ Crossovers
    ±18dB Variable Bass Equalization @ 45Hz
    180° Variable Phase Control (15 to 35Hz)
    Dash-Mountable Bass Remote Control Included
    Variable 24dB Subsonic Filter
    Brutus Pulse Wave Modulated MOSFET EXVP (Exponential Vari-Power Supply)
    HSMD Hifonics Surface Mount Design
    Balance Line Inputs for our 18-Volt Line Drivers
    Silver RCA Line Output for Amplifier Daisy Chaining
    Gold Oversized 2-Gauge Power Connectors
    Remote bass control Included
     

    Attached Files:

    Last edited: Mar 26, 2008
    electrolytic, Mar 26, 2008
    #591
  12. electrolytic

    electrolytic Full Member

    .........................................
     

    Attached Files:

    electrolytic, Mar 26, 2008
    #592
  13. cccullen

    cccullen Full Member

    Nice amp electro, whats the RMS for your stroker? 2000???
     
    cccullen, Mar 26, 2008
    #593
  14. electrolytic

    electrolytic Full Member

    ya 2000 watts rms dual 2 ohm
     
    electrolytic, Mar 26, 2008
    #594
  15. cccullen

    cccullen Full Member

    I'm sure Hifonics don't put out rated power, anyway just put the gain down. Get the Hifonics Bxi 2407D. I'm sure that Cerwin Vega can handle it.
     
    cccullen, Mar 26, 2008
    #595
  16. electrolytic

    electrolytic Full Member

    ok, it's hustle time!! I just put the orion on ebay for $280 buy it now. Ley's see if i get any bites. I'm so over this whole car audio thing!! I want it done already so i can move on to other things...
     
    electrolytic, Mar 26, 2008
    #596
  17. electrolytic

    electrolytic Full Member

    fuk, i can't sleep...lol
     
    electrolytic, Mar 26, 2008
    #597
  18. cccullen

    cccullen Full Member

    LOL. I saw it on ebay...
     
    cccullen, Mar 26, 2008
    #598
  19. electrolytic

    electrolytic Full Member

    i got a bite already lol, offering me $200
     
    electrolytic, Mar 26, 2008
    #599
  20. electrolytic

    electrolytic Full Member

    Screw it, i sold it for $210 plus shipping, and i don't care, lalala la la because it helped me to buy THIS!!!!!!! WOOOOOOFKNGGGGGGGGHOOOOOOOoooooo LOL
    It's mine babyyyyyyyyyyyy

    Hifonics Brutus BX2200D Anniversary Edition 2200w RMS mono amplifier

    * 2200 Watts x 1 Chan. @ 1 Ohm RMS
    * Class D Mono Amplifier
    * Super D-Class Chip Set
    * Hifonics Twentieth Anniversary Heatsink
    * Illuminated Hifonics Badge
    * Illuminated Maxxsonics M
    * Bass Remote with Blue LED Power On & Diagnostic Indicator Included
    * Ultra-Fi MOSFETS
    * SPC - Simpatico Coil Design
    * HSMD - Hifonics Surface Mount Design
    * Fully Adjustable Accu-Cross Crossovers
    * PWM MOSFET Power Supply
    * Soft Start
    * Line Output
    * XLR Mini DIN Sockets for Balanced Line Input
    * Variable Bass EQ: 0 - 18 dB
    * Sub-Sonic Filter: 15 - 35 Hz
    * Variable Input Level: 200mV - 9V
    * 2 Gauge Power Connectors
    * Additional MOSFET Output Devices
    * Dimensions: 20.5" L x 2.63" W x 10.39" H

    Specifications:

    * Number of Channels 1 - Mono
    * RMS Power (4 ohms) 550 watts x 1 channel
    * RMS Power (2 ohms) 1100 watts x 1 channel
    * RMS Power (1 ohm) 2200 watts x 1 channel
    * Peak Power Output 4400 watts approx.
    * Minimum Impedance 1 ohm
    * THD at Rated RMS Power 0.1%
    * Preamp Outputs 1 pair
    * Built-in Crossover LP ( 35 - 250 Hz), Subsonic(10 - 20 Hz )
    * Signal-to-Noise Ratio 95 dB
    * Bass Boost 0 - 18 dB (30 - 60 Hz)
    * Fan Cooled Yes
     

    Attached Files:

    electrolytic, Mar 26, 2008
    #600
Page 30 of 64