/ Register

vibrating/speaker location/box design

Discussion in 'General Car Audio Discussions' started by Ghiti, Mar 15, 2010.

Page 2 of 2
  1. pedro quiroga

    pedro quiroga Well-Known Member

    with what you want to build i would assume it would sound like a nice set of book shelf speakers.

    i understand the ease of removal part. didnt think about that. i dont think the box needs to be 3/4'' unless thats all you have.

    i wanne see pics when done. :)
     
    pedro quiroga, Apr 3, 2010
    #21
  2. Ghiti

    Ghiti Full Member

    it'll all be 3/4 except the top(baffle), the top's going to be 1/2. i havn't worked out how to secure it in my trunk yet thou :p any suggestions on that? i was thinking some straps to tie it down and and against the back seats.
     
    Ghiti, Apr 5, 2010
    #22
  3. cccullen

    cccullen Full Member

    You could use straps, or you could use L- brackets too. That box shouldn't be too heavy so you could also use velcro, a lot of velcro but i'm not too sure if that will be safe if you have to make a quick stop.

    Another way is make a overhang on the bottom of your box and if you have any bolts on the floor of your vehicle then you can remove them and rebolt it with the box attached.
     
    cccullen, Apr 5, 2010
    #23
Page 2 of 2