software

I didn't change that setting, should i have? This is what it is at.

 

plot, velocity

 

vent:no: :no:

 

box, what's with the plot crosshair thing that you move, am i looking for a certain frequency at 0 decibles where the wave crosses?

 

sweet

 

i don't know just checking it out, not used to it yet. Is this it?

 

Cool thanks, will try more with winisd to see if i can get that info, this bassbox pro doesn't have excursion as far as i can see but it is very nice, shows the individual pieces you need with measurements and everything. Cool. Does this look good besides the excursion part? The tuning within range?

 

:wacko: :wacko: :wacko: :wacko: :wacko: :wacko: :wacko: :wacko: :wacko: :wacko:

 

well, i think my design is almost complete!! I want to have the sub facing my back seats because they fold down, have the ports firing through the rear deck where i will remove the 5x7s and that way i can mount the amp on the back of the box on the trunk side, Yes? No? Maybe? lol

 

ohhhhhh......lol ok the sub has over 1 inch excursion Xmax so i guess i can't go past that red line? This design is wrong?

 

hmmm, only way i can get this sub to go below the xmax is to go sealed

 

:jawdrop: :jawdrop: :jawdrop: :jawdrop: :jawdrop: :jawdrop: :jawdrop: :jawdrop: :jawdrop: :jawdrop: wave output

 

Gotchya, cool Thanks, I'm getting there! I guess i can cut the crossover at 28hz or something so the speaker won't go crazy below that. Ya i though the vents were small but that's what the program suggested. The orion sub's FS is 30.98hz or something like that, should i try and match that frequency with the ports?

 

Cool, so cone excursion and cone displacement are the same. Thanks! wooooooooo this program is sweet!! Where the curve fades color, does this mean basically don't worry about the faded out part of the curve? lol does that make sense?