New Driver From Adire

Extremis 6 (mounting) depth measurements would be very helpful. I have the processing to go all active, so if it's fits in my door...

 

I know i'd like to see a Koda 5.1 or 4.1 for 3-ways, Especially if they bring in the XBL^2 motor technology in on them, It'd probably sound sweet tri-amping... US Amps TU-600 for the Extremis (i already have this amp running my polk MM6's) and a US Amps TU-4360 for the smaller woofer and tweet....


Speaking of XBL^2, are there any plans to bring that in on the components? I'm sure i'm not the only one who'd love to see that

 

What, can't fit a koda 8 into your comp set? :lmfao:

 

naah, the brahma's will cover the low end well enough

 

I said it FIRST! And, perhaps I'm wrong, but I'd assume that XBL2 might be wasted in a speaker such as a smaller midrange where most of your frequencies are higher and excursion is much lower.

 

High excursion = always good!
(with the caveat that it's linear excursion)

Gives you the ability to get louder... as well as have lower frequency extension from a smaller driver...