Separate names with a comma.
ok thats all I needed...I just need to fill in some information. I finally got a notebook to keep track of everyones designs and the information...
Pedro No Wires Showing Yay!!!!!
Well do you want a design that spans the whole width??? That brace in the middle is a dowel rod...either 1.5 inch diameter or 2 inch...
take a length of 18 gauge wire and ground the HU chassis to the chassis of the amp that is making the noise
Sh!t i really need to get my paypal account up...the most I would charge for a design is $10 if it is for a more complicated and bigger design....
I wish there were more shows and competitions around my area.
cccullen here you go 5 cu ft at 33hz All vertical boards are 17.5" tall [IMG] [IMG]
is that you in the green shirt??? looks back breaking lol
Welcome....are you a giant man??
cccullen you want a slot port or two 6 inch round ports??
how wide of a box can fit in your trunk?
my knukonceptz 4 gauge is bigger than kicker hyperflex 4 gauge
a lot of late night traffic...its 1:45 in the AM here
dB-r Electronics
I'll try to get it by tomorrow night...I forgot all about your enclosure...my bad lol I have tried to write down the names and enclosures that I...
I'd rather get this than that amp you listed Power Acoustik PS4-840 - 4 ohms: 80 watts x 4 • 2 ohms: 95 watts x 4 • Bridged, 4 ohms: 190 watts x...
I've done it...works fine. Just don't put to much power to em. To 10s in a nice box should get pretty loud though
Well two 10's have significantly less cone area than a single 15. If you were going to use the 15 you could always use one coil...power handling...
if it hasn't shipped yet I'd call the place and see if you can correct the problem?
Cheap route I'd get these Parts Express:Dayton RS225-4 8" Reference Woofer 4 Ohm Expensive route maybe these. Audiopulse
