Separate names with a comma.
The Sony CDX-GT23W Installation Manual does list the wire color codes.
Determine the requirements, how loud for how long, engine on or off? Then figure the ampere-hours required, the available ampere-hours from the...
The 3,200W can pull over 250A from the electrical system. The batteries will be a buffer, with more going out than going in. The ampere-hour...
When I was selecting new batteries for my boat, to me the important requirements were maintenance-free (met by AGM batteries) and long run time...
Yes, follow the wiring diagram. For safety the fuse should be close to the battery. All the wires should be secured along the length. All...
Yes, use the battery negative.
Pick a battery, then select a charger that is appropriate for that battery. The AGM batteries like lots of current, per the specifications, so...
The specification section of that manual is poorly written. A properly written manual will list the minimum acceptable impedance for the...
Yes, the manual for the SX-X360 lists the amplifier specifications as: RMS Power Output / 100W per channel / 10% T.H.D. / 4 Ohm. The usage of a...
Remove the factory trim to expose the factory wire pathways. Run the new wiring next to the factory wiring. Post an image of the issue to...
The big disadvantage to using a cooler for an enclosure is that it is designed to resist heat flow. The amplifier and charger inside the box get...
That is correct. In this simple example there are now two identical 4 ohm current paths out of the amp. The equivalent circuit to the amp is a...
Yes, the two four ohm can be connected in parallel to create a single 2 ohm load, as viewed by the head unit or amplifier. The next step is to...
Another good option for terminating battery cables, without an appropriate crimp tool is to use the NAPA compression battery terminals. For 2/0...
My six flooded cell group 31 batteries were getting tired, so I upgraded them to six group 31 Lifeline GPL-31XT AGM batteries. I selected these...
