Separate names with a comma.
Hi sorry for late reply. I am going to get a set of components and switch for 6x9s. With the sub amp frequency I don't see any real difference...
hi, i have just installed a new sound system in my ute. i have replaced the stock door 4" with fusion speakers. behind seats there are 2 6x9's...
so the mesh strap that goes from body to engine needs replacing? and just soldier a wire to body of alternator and run it to negative on...
I have fixed alternator whine by putting a noise filter on the amp line but have to set the gain on the amp to minimum with engine off then with...
so how do i re ground everything? i did notice that the cable from negative on battery is looking a little rusty and corroded. so for the...
also did a random test today, i put an rca to headphone socket cable into the input on the amp and plugged other end into my ipod and i didnt get...
did that and still noise i connected both negative and positive to battery and amp was away from the car. although i ran a battery charger to the...
new grounding location didnt work. does that voltage difference have anything to do with it? thanks
ok thanks il try move the ground point. Also i used a multimeter to test voltage on the batt, head unit and amp and there was about 0.3v...
well the ground is connected to a bolt that holds the seatbelt harnes in place.
the remote wire is ran along side the power cable to the amp. From head unit, down to floor then ran under carpet till it gets to amp.
hi guys, i have just installed an amp to power my 6x9s at the back and anyway when the key is turned to the acc position i get clean audio,...
