Separate names with a comma.
How would i wire in the other battery? Just run pos/neg from my current battery to the 2nd then from the second battery to the amp? Would going...
If i wired each sub to 2ohms alone and connected each to there own positive and negative would that show a 4 ohm load? I have the subs wired just...
Can anyone tell me the best way to wire my situation? [: Subs: Two 10'' Rockford Fosgate P3d410 Duel 4 ohm. Amp: Kenwood 9150D 900 watts @...
I believe it's 90amps. Is there anywhere i could buy new battery terminals and 0 gauge wire terminals ( i know where to get them online, but im...
Yes, everythings stock, i'll check the batteries voltage tomorrow. Would changing the alternator be a big project? Also where would i buy one...
its at 12.6 with car off. The max while its hitting hard is 14.2 volts, but after running for a few minutes it drops to 13.1 and then spikes down...
Protection isnt coming on. Where do i touch the DMM to check for the right voltage? and should it be closer to 12 or 14 volts?
Anyone got any ideas?
The box is to spec. The gain is at .5 and bass boost is at 8. Basicly every song will start out bumping hard, but around 45 seconds you can hear...
I have a Kenwood KAC-9105D amp running two 10’’ Rockford Fosgate P3D410 subs at a 1 ohm load. My problem is that when the bass hits hard the amp...
