Separate names with a comma.
Thanks guys
So fill the enclosure with the peanuts, then pour them into something of known volume? Does this sound about right? Thanks guys
Is there an accurate way to find the internal volume of a fiberglass enclosure? I've researched the net and came up dry. I know that rough...
I'm a little confused about amp wiring. Say I have a SVC 4 ohm driver bridged mono (+ of one channel and - of the other). What resistance load...
The vehicle is a 2000 Dodge Ram 3500 quad cab. I'll try to post the curves that I came up with.
Right, the 10W3v3-8's have a single 8 ohm coil. The 10W3v2-D4's have dual 4 ohm coils. After looking at the response of each, I am leaning toward...
Viking, I plugged the parameters for a JL Audio 10W3V2-D4 (10" - 4 ohm DVC) into my enclosure software (bassbox lite). With an internal volume...
Ok, so no 2 ohm bridge for the amp. That said, should I opt for the 4 ohm versions wired series to make 8 ohm total load then bridge for a 4 ohm...
I am looking for some information/reviews on Planet Audio's VX4004? I was thinking to use it to run a set of Polk MMC 6500's in front and a pair...
