Viking Audio

sweet, thanks electro. I think I going to make this next weekend and then i can compare the two boxes. Then I can decide which one I'll have upholstered.

Thanks again. I have a question. What kind of glue are you using to glue/seal the port in?

 

http://www.hexibase.com/gallery/main.php?g2_itemId=527

do it like that, if anything make your holes slightly smaller than the port then sand it out. Its worth the extra work for a good fit and clean look. just use caulk on the inside to seal it cause trust me if you do it right its not going anywhere. You wanna make it realllllll snug.

 

Yo G3 what was the size and tuning of the box we figured out for your friends Ov.2s??

 

4cuft @ ~33hz

 

got it. get that going this saturday. so this is about 4.6 cu. ft. and what's the tuning?

 

didn't you say it was pretty loud??

 

broke the seal on his windshield as a daily driver. thats in a chevy aveo hatchback though.

 

that's loud! that's nowhere near where mine is at now.

 

he has a nine.1 as well, at full tilt it runs at 14.2v so its more like ~1550rms

 

gotta ask you on this. does that box look like it would really slam the 13Ov.2's? I want a box that will really make them pound hard.

 

well the box you built is pretty similar to the one i built for my friend. only his was side ported. that may be a consideration.

 

lol. it will get the lows really good too??? that is a big step up from my current box. my box now just hits around 4 cubes.

 

cccullen - i would give electros box a go. the 4cuft box i did for my friend was loud and all but i think it could get louder and lower. as you probably know the larger the box typically the lower the sub can hit to an extent.

 

ok, last question (I hope). Does it matter where I'll be putting the round ports? and the subs? I'm just asking cuz the design doesn't give measurements on the placement of the subs or ports.