Separate names with a comma.
i found this in another forum is this right??
i got my new amp its a mono it has 2 sets of speaker terminal it puts out 1000w rms @ 2ohm and 1000w @ 4ohms how do i wire each sub by itself...
I have 300 and each sub is 400 watt rms
Does PPI Make Good Amps? I could get this one for my 2 jl w6v2 for 175 should i?? http://www.precisionpower.com/amps/pcx2200.asp
http://losangeles.craigslist.org/wst/ele/815361637.html what about this one????
i think they take 400 rms each
I Got Rid Of It I Sold It To One Of My Friends Can You Guys Help Me Out Choosing An Amp For Both W6v2 I Got 300.00 To Spend
http://losangeles.craigslist.org/lac/ele/810220206.html ARE THESE GOOD AMPS WILL IT PUSH THE 2 W6V2? I COULD GET IT FOR 155.00
Whats A Good Amp With The Same Kind Of Power As The1000/1 Does Total Mobile Audio By Jl Audio Make Good Amps I Was Looking At The 1000.1 theres...
Does Any one know were i could get a good deal on this amp?
I JUST DECIDED TO BUY A NEW AMP FOR MY 2 JL AUDIO W6V2 WHICH ONE WILL WILL BE A GOOD MATCH ??? GOT 200.00 TO SPEND ON IT what do you guys...
so if i wire each w6v2 @ 2 ohms each sub and connect each sub to to the terminals at the amp how many ohms am i running it at?
The Box Has 2 Terminals One For Each Sub
so i would have to drill a hole on the middle divider of the box to pass the wire?? my amp has two sets of terminals on it something like a two...
What does this mean it says on the sub terminals configure dvc jumpers in series for 8ohms or in parallel for 2 ohms see manual.....so does this...
PLEASEEEEEEEEEEE Help Asap I JUST SCREWED OUT MY W6V2S AND WANT TO TRIPE CHECK THERE WIRED RIGHT BEFORE I SCREW THEM BACK IN SO HERES A LIL...
is it from vc1- to vc2- and vc1+ t0 Vc2+ and connect the speaker wire at the + - Terminals??? its that how you wire the sub at 4ohms??
my bad im stuck again lol how would i do the wire from negative to negative and positive to positive on this sub this it what it looks like [IMG]
Yea it hast 2 sets of terminals on the amp its ++-- that helps alot i thought i was going to have to drill the box and pass wires from one side to...
is there a way i could wire them using both the terminals in the box?? but still have a 4 ohm load??...
