Collaborative Enclosure Design Thread

I'd like to see that. that should pound!!! with my box, i want it to be a full 48 in width, i still have to measure the height, and my depth can be whatever it needs to be...

I want to do another box, i took the whole system out because i was going to sell my expy, since it didn't sell, the system is going back in now but I want to change the look of it again so this is why i want to do another box...

What would be good tuning for the 13O.v's? I forgot what the tuning of the box that electro did for me before... I have no problems at all if the box will be bigger...

 

here are the measurements... 48" width and 17" height. depth can be anything you want.

 

I'd like it for sure to be 52-53in wide, 14.5in tall, and about 20in deep, the depth can be increased a bit if it needs to I think

 

Azn, help me and jonny out!!! Please...............

 

haha ya! I'm itchin to try a t-line!! LOL

 

What about a low ft^3ed Long ported box/cylinder, and use the long vent line in a circular motion, Kinda conical like or spiraling out, you know what i mean? (or do i just sound like a stoner?) but seriously i think that would be a cool build, do a 14 inch plate mount a 12 to it then build a 12 inch tall tube, and port it out in a spiral. (the port would be huge on a tube like that but it would still be a fun build and an interesting deign you know?)

 

Stoner for sure. Haha but I can't bitch

 

Ite, thanks Azn.

 

ya i havent yet but im sure i can

 

azn, don't forget about my box. i'm itching to do my install again. just waiting for a box design so I'll know how to do everything else.

Thanks again!!!

 

so im looking to get creative on the box for my mustang I was thinking free air but sealing this car up really well is just alot of work... I have two 15in Fi Q subs that were modified with a triple stack magnet for more power handling but im only going to give them 200watts a piece... I tested them out and they move a good amount with that power... im looking to port into the cabin behind the back seat and seal off the port from the trunk... its going to be a two section box and the subs are going to face up at the trunk lid... the measurements I took are width:57in height:8.5in depth:16in that for the first part and second width:45in height:8.5in depth:23in its around 6.9 cu.ft before sub and port displacement is that sufficient? cause I dont have a clue how to port it... any questions on what im actually talking about, just ask? I want it really impressive. thanks.

 

thanks azn. even though i cant see it right now cause i am on my comp at school and pictures are blocked right now i guess...

 

sweet t-line!!! We want to see some pics jonny! get on it!!!

Thanks azn, I'm getting my stuff together now. I just picked up a run of 1/0 ga. of 30ft. got it from a friend and he's only charging me for 20ft at $3 a foot the other 10ft he threw in for free. If i buy it new here then i'll be spending $8 a foot. I'm retiring my welding cables. lol

 

thats sweet! do u think i can do it all with one 4x8 sheet?